Contact Form

 

 

First Name
Last Name
City
Email Address
Daytime Phone
Evening Phone
Tell us about your project
	= Required

Contact Information

 

 

Contact: Integrity Plumbing
Address: On Call
Phone: (770) 667-9435
Email: This email address is being protected from spam bots, you need Javascript enabled to view it
Website: www.ips-plumbers.com

FAQ

 

 

 

water Temperature & Water Bills
	The temperature of my hot water seems to be higher than what I think I need. How can I conserve energy, yet also be sure that there is an adequate amount of hot water?
	Most people are comfortable with their hot water set at 120�F, which is also the new standard that manufacturers use when pre-setting it at the factory. If you have an older model, set the thermostat at medium. On a gas model, there is a dial on the front of the gas valve. On electric models, the thermostats (there may be two) are concealed behind the two panels on the side of the tank. NOTE: Turn off the electricity before removing the panels. There are exposed wires behind the panels containing HIGH VOLTAGE.
	There are four people in our house, two adults and two teens. We are constantly running out of hot water. After a five-minute shower, the water starts to turn cold. This change occurred quite recently. Help!
	There are two possibilities. First, the dip tube has broken off. This is a tube that forces incoming water to the bottom of the tank so that hot water will be drawn off of the top. When the dip tube breaks, cold water entering the tank mixes with the hot water and cools it down. This can occur in both gas and electric models. Second, if your water heater is electric, the lower element that heats the water may not be operating properly, thus only the upper half of the tank will heat up. The cause of this problem could be a bad element or a thermostat malfunction. This type of problem should be evaluated by a qualified technician.
	Recently my water bills appear to be rather high. None of the faucets appear to leak. What else could contribute to a high water bill?
	You may want to check to see if a toilet is leaking. First, check the water level to ensure that water is not overflowing the tank by way of the overflow pipe. This is the pipe in the middle of the tank. It has small tubing connected to it. If water is running into the overflow, adjust the fill valve to stop the flow approximately one inch below the top of the overflow tube or to the water level mark stamped on the side of the tank. Second, put a few drops of food coloring into the tank to test the flush valve mechanism. If the water in the bowl changes color within 15 minutes, this is an indication that water is leaking into the toilet bowl and that the ball or flapper needs to be replaced.

 

 

Portfolio

 

 

 

Exclusive Offers

 

10% OFF WHEN USING 411HOMEWEB.COM   

  

Testimonials

 
Great job thanks for all of your hard work and on time service!!!!

 

Steve Walmock

 

Driving Directions

 

Click Here For Driving Directions